[BigRedRider]

Has anyone replaced thier throttle sleeve? :?:

I cracked mine while screwing on the handlebar pointed ends.

I would like to replace it with a sleeve made form aluminum, not nylon as it comes from Honda.

I can find aluminum sleeves, but none specifically say they fit the rune (or Valkyrie). So before i start experimenting and testing, I am hoping someone else has already went down this road.

Any help would be appreciated. Thanks,

BigRedRider

 

[Jeff Kehoe]

Me too!

ME TOO!!
I broke mine also!

 

[LOV2KRZ]

Not Sure

I replaced mine with a Honda sleeve and bought the bar ends from HDL and it works fine.

 

[Roomtomove]

Hello All,
I was one of the first to break the throttle sleeve with the HDL bar ends. Who knew you were not supposed to tighten them? I got mine repaired under warrenty ( a bit of foolery on my part ). Now I keep a close eye on them both to make sure they don't get too tight. It is a bit of a pain. If I could find an alternative sleeve I would replace the plastic one. Seems to be a poor design at best.
Greg