Rune Rider Forums banner
1 - 4 of 4 Posts

· Registered
58 Posts
Discussion Starter · #1 ·
Today i backed the rune into a curb. The rear fender is just the right height to get scratched from curbing right at the bottom where the fender starts to roll under.

Can you make a chrome trim piece for the rear fender, that has the same shape so it will protect this area. Only needs to be about 3/4" wide (to fit under the license plate light) that will fit on the three sides of the fender. This may not have mass appeal, but i want one.

1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.